INFICON Sensistor ISH2000P Hydrogen Leak Detector, Panel Model - Manual (Page 19)

Hydrogen leak detector Sensistor ISH2000 - Operating Instructions
OP-Sensistor ISH2000-EN-201203 17
EN
8 Reference section
This section of the user manual consists of an in-depth explanation and additional
information, which completes the user manual with all relevant information.
8.1 Menu system
The menu system is designed as a tree structure similar to that used in mobile
telephones. The display shows all the levels when browsing down through the
menus so that you can always see exactly where you are.
Fig 8-1. Sensistor ISH2000 controls and indicators.
To enter the menus, press Menu (button 4). Press < and > (button 2 and button 3) to
choose between main menus.
If no setting is made in a menu or its submenus within 60 seconds, the instrument
will revert to the
Detection Mode/Analysis Mode .
Button functions
The buttons may change functions in different menues. Always read the text, just
above the buttons in the display, for the button functions.
All changes in values are valid only when saved using the Save button (button 4).
Use the Undo button (button 1) to delete a change in value and revert to the
previous setting.
Use the Esc button (button 1) to browse backwards through the menus to the start
position Detection Mode/Analysis Mode .
To change quickly from Detection Mode to Analysis Mode or vice versa, press button 4
three times in succession.
8.2 Engineering format
Some of the parameters of the detector are written in engineering format. This
format can represent a very wide range of numbers from very small to very large
numbers.
The following examples describes the format used in the detector:
1.00E+01 = 1.00 x 10
1
= 10
1 2 3 4