INFICON Sensistor ISH2000P Hydrogen Leak Detector, Panel Model - Manual (Page 40)

Hydrogen leak detector Sensistor ISH2000 - Operating Instructions
38 OP-Sensistor ISH2000-EN-201203
EN
Parameters can be sent in any order you like:
•
If your data was received and correct, Sensistor ISH2000 immediately echoes
(sends back) the data.
• If you send a non existing header you will not receive anything.
• If the data could not be converted in the Sensistor ISH2000 you will receive the
string “CoEr”, (Conversion Error).
Note: Remember to use capitals for the header.
APC driver installation
APC drivers are installed in the detector from a PC. All active probes need a driver to
be installed before they can be used.
Note: Battery operated model Sensistor ISH2000 does not incorporate the APC
feature.
For driver installation you will need the following:
•
APC Driver software. (Delivered with the probe.)
• File transfer cable. (Delivered with the probe.)
• PC computer with Windows 95 or later.
8.15 Sensistor ISH2000P installation
The panel mount model can be installed in the operator’s panel or any other flat
surface of your leak tester. Mounting brackets and panel rubber seal are delivered
with the detector. Refer to Figure 8-6.
Fig 8-6. Panel cut out dimensions.
CAUTION!
The detector should preferably be mounted on a
vertical surface. Tilting more than 30 degrees is not
recommended. Tilting more makes air circulation
poor resulting in increased temperature inside
detector. This will reduce contrast of display and
lifetime of lamp and electronic circuits.
NOTICE!
After installation verify that ambient
temperature is below 50ºC.
Sensistor
Free space horisontally
262 mm (10.3 inches)
127 mm (5 inches)
Free space vertically