INFICON HLD6000 Refrigerant Leak Detector User Manual
Hld6000, Translation of the original operating instructions, Leak detector
Advertising
Table of contents
Document Outline
- HLD6000
- Table of Contents
- 1 About these instructions
- 2 Safety
- 3 Shipment, Transport, Storage
- 4 Description
- 5 Installation
- 6 Operation
- 6.1 Switching on the device
- 6.2 Operating the device
- 6.3 Basic settings
- 6.3.1 Setting the language
- 6.3.2 Setting date and time
- 6.3.3 Adjust volume
- 6.3.4 Setting auto standby
- 6.3.5 Setting the display
- 6.3.6 Set time interval for calibration request
- 6.3.7 Switching the request for replacing filters on or off
- 6.3.8 I/O module
- 6.3.8.1 Create a connection between the device and the I/O module
- 6.3.8.2 Configuring analog outputs
- 6.3.8.3 Setting the upper scale value for 10 V of the analog output
- 6.3.8.4 Setting up the I/O module protocol
- 6.3.8.5 Configuring PLC outputs
- 6.3.8.6 Configuring PLC inputs
- 6.3.8.7 Setting the interface unit
- 6.3.9 Set up scope of error messages
- 6.3.10 Access to the settings
- 6.3.11 Save parameters
- 6.3.12 Load parameters
- 6.4 Settings for the measurements
- 6.5 Standby
- 6.6 Diagnosis
- 6.7 Calling up information about the device
- 6.8 Updating the software
- 6.9 Switching off the device
- 7 Warning and error messages
- 8 Maintenance
- 9 Decommissioning the device
- 10 Appendix
- Index