Intelix ASW-WP Installation Manual - Manual (Page 15)

ASW-WP Installation Guide
RS232 and TCP/IP Commands
RS232 Settings: 9600 baud, 8 Data bits, 1 Stop bit, Parity = None
<CR> =
Carriage return (Hex 0D)
<LF> =
Line Feed (Hex 0A)
<SP> =
Space (Hex 20)
*NOTE: You must turn Display Control OFF in order to gain control of the ASW-WP via RS232 –
please send the “Display Control OFF” command first! (See page 16)
System commands
Description Command Response
Select HDMI input
SET HDMI<CR><LF> SET HDMI!<CR><LF>
Select VGA input
SET VGA<CR><LF> SET VGA!<CR><LF>
Get selected input
GET IN<CR><LF> GET IN!<CR><LF>
Get HDMI video status
GET HDMI<CR><LF>
HDMI 1!<CR><LF>
This response indicates video
present on HDMI input
HDMI 0! <CR><LF>
This response indicates NO video
present on HDMI input
Get VGA video status
GET VGA<CR><LF>
VGA 1!<CR><LF>
This response indicates video
present on VGA input
VGA 0! <CR><LF>
This response indicates NO video
present on VGA input
Turn auto-switching on
AUTO ON<CR><LF> AUTO ON!<CR><LF>
Turn auto-switching off
AUTO OFF<CR><LF> AUTO OFF!<CR><LF>
Enter low-power mode (will disable
RS232 communications until
physical action wakes up ASW-WP)
STANDBY<CR><LF> STANDBY!<CR><LF>
Reset microprocessor
RST<CR><LF>
No response – ASW-WP will power
cycle
HDCP Compliance ON
HDCP ON<CR><LF> HDCP ON!<CR><LF>
HDCP Compliance OFF
HDCP OFF<CR><LF> HDCP OFF!<CR><LF>
Get HDCP Compliance status
GET HDCP<CR><LF>
HDCP ON! <CR><LF>
Or
HDCP OFF!<CR><LF>
15