JUMO 14597 safetyM STB/STW Ex - Safety Temperature Limiter and Safety Temperature Monitor Operating Manual - Manual (Page 31)

5 Startup of the device
25 2013-04-01
5.3 Selecting and editing parameters (plausibility requirement for input values)
The values are displayed in the normal display.
To edit a value – such as the limit value – perform steps 1 to 4
1 Press The first "Analog inputs" menu item is highlight-
ed in black. The vertical line to the right shows
the current position.
2 Select limiter/monitor with
Switch to submenu with
3 Press 2x until limit value appears
Press (limit value blinks)
4 Set value of your choice with or
Acknowledge with
(limit value appears twice)
The limit value flashes
twice for checking pur-
poses
5 Briefly press to confirm.
The value are adopted and saved. Back to normal display:
Use
or , "Return" menu item, or auto-
matically after timeout.
H
If no key is pressed for 30 seconds (timeout) then the device automatically returns to normal display and the value is
not stored. The duration of the timeout can be configured.
v
See operating overview on the first inner page of this manual.