Kinze 3110 Mounted Planter Rev. 7/14 - Manual (Page 22)

M0244-01 Model 3110
2-10 9/12
TM
Machine Operation
The digital vacuum gauge console controls EdgeVac vacuum fan. Use “FAN 1” setting when planter is equipped with
one vacuum fan.
NOTE: Toggle switch must be OFF when planter is not in use or tractor battery will drain.
The digital vacuum gauge is factory calibrated. However, vacuum varies throughout the manifold system and it may be
necessary to adjust the digital readout so it agrees with actual vacuum at the meter. With the seed discs loaded with
seed, compare digital vacuum gauge readout to reading taken from analog gauge or a hand held gauge at several
meters along length of planter.
Elbows at seed meter covers allow testing of meter vacuum levels without removing vacuum hoses. If there is more
than 1" or 2" (H
2
O) difference, adjust gauge by inserting a small flat bladed screwdriver into opening on back of digital
gauge housing and turning potentiometer until digital gauge displays meter vacuum reading.
Compare readings at 10" and 20" of vacuum.
DIGITAL VACUUM GAUGE OPERATION
ANALOG VACUUM GAUGE
The analog vacuum gauge connects directly to the manifold or
is teed into the digital sending unit on newer models.
Only gauge adjustment is to “zero” needle with no vacuum
present. If there is a significant difference between this gauge
and a reading taken at meters, a different manifold location
should be found to connect hose to gauge and digital sending
unit.
Digital vacuum gauge
Analog vacuum gauge
Kinze EdgeVac seed metering system includes seed meters, seed discs, and an air system consisting of a hydraulic
driven vacuum fan which draws air through manifolds, hoses, and seed meters on each row unit.
wARNING
Moving fan blades can cause amputation or severe injury. Never
operate vacuum fan with cover removed.
EDGEVAC SYSTEM