Alarms, Isobus m0246, 27 alarms – Kinze ISOBUS Electronics Package (3000 Series) Rev. 5/14 User Manual
Page 33: Rev. 5/14, Vacuum
If a threshold is crossed (either high or low), an alarm screen will appear and the data cell with the corresponding data
will turn red.
There are two sections to the alarm screen: the large box at the top and the box at the bottom.
The large box will contain the most current alarm. The function will be listed first, followed by the alarm state (i.e. high
or low), then the position or row. The box at the bottom of the screen contains all of the active alarms as well as a
counter of how long the alarm has been active. The up and down arrows on the right side of the screen can be used
to scroll through alarms.
If you select ACK CURR, it will acknowledge the current alarm that is shown in the top box. If you select ACK ALL,
all alarms will be acknowledged and you will return to the plant screen. Acknowledging the alarm will not clear it. The
alarm box will appear at the top of the plant screen until you correct the problem or the value returns to inside the
threshold and the alarm clears itself.
Note: No matter what screen you are in, the alarm will always pop up over it.
If you acknowledge the alarms and return to the plant screen a status box with the alarm status will appear at the top
of the screen. It is red and will say ALARMS and then will state how many alarms are active. If you need to return to
the list of alarms simply press this red button and you will return to the list of alarms.
Note: See settings to change alarm thresholds.
2 OF 4
L 0 . 0
R 0 . 0
ACRE / HOUR
ALARM- 2 TC
A L A R M
Position: Right - Low
All active alarms
Alarm Box on Plant Screen
indicating alarm has been
acknowledged but not cleared