Landoll BDH512 Double Seeder Hitch - Manual (Page 11)

2-1
Chapter 2
Assembly
The intent of this chapter is to provide proper assembly
instructions for the implement. The reference numbers on
the following pages provide an indication of assembly
order. Refer to Parts Manual F-646 for complete part
breakdowns and proper location of any parts not shown
in the following illustrations.
Location reference: Right and Left designations in this
manual are determined by facing the direction the
implement will travel during field operation, unless
otherwise stated.

CAUTION
IMPORTANT
If a pre-assembled component or fastener is
temporarily removed, ensure it is correctly
re-installed per these instructions.
Check that all working parts move freely, bolts are
tight and cotter pins are spread.
See page 4-1 in the Maintenance Chapter for proper
bolt torque values.
Note the different torque requirement for bolts with
lock nuts.
Select a smooth level area that can be reached by a
hoist or lift truck.
Drawbar Assembly
1. Attach each Hub and Spindle with a 3/8-16 x 3 Hex
Capscrew and Locknut. See Figure 2-1.
2. Attach a Wheel and Tire Assembly to each Hub and
Spindle with six 1/2-20 x 1 Wheel Bolts.
3. Install Jack.
4. Attach Safety Chain using one 1-8 x 2-3/4 Hex
Capscrew, three Flat Washers and one Lock Nut.
5. Attach 4K636 Hitch using two 3/4-10 x 6-1/2 Hex
Capscrews and Locknuts.
6. Attach Hose Holder and Hose Support with a 5/8-11
x 2-1/4 Hex Capscrew, Flat Washer and Locknut.
See Figure 2-2.
7. Attach Connector Holder with two 1/4-20 x 3/4 Hex
Capscrew and Flange Locknut.
Do not work on or under this machine unless
securely
blocked and supported by a hoist or
tractor or by other sufficient means!