Landoll BDH512 Double Seeder Hitch - Manual (Page 24)

2-14 F-645
ASSEMBLY
S-Tine Tire Track Remover (Optional)
1. Attach brackets to the frame with U-bolts (1/2-13 x
4-1/2” centers x 7-1/2” deep), lock washers, and nuts.
Note that the long ends of the brackets are
downward. The bracket on the Transmission side
should be about 13-1/8” from the frame inner plate
and on the opposite side 10-1/4” from the frame inner
plate. See Figures 2-14, 2-15.
2. Attach the tube to brackets using straps and bolts
(1/2-13” x 6”), lock washers, and nuts. At this time
ensure the hydraulic hoses are positioned over the
top of the Brackets. See Figures 2-14, 2-15.
3. Locate and install the S-tines to cover the tractor tire
tracks. The first tine on the front is 15-3/8” and the
first tine on the rear seeder is 18-3/8” from the end of
the long tube. The rest of the tines are positioned
7-1/2 inches apart consecutively inwards towards the
center of the hitch or tractor. See Figures 2-14, 2-15.
NOTE
Duckfoot points on each end and 6 reversible points in
between.
4. If needed, additional tines may be purchased and
installed.
The Wheel Track Remover is furnished with 16 S-tines.
Additional or fewer tines may be used as required.
NOTE
Tube 9J962 provided with this kit is for 12 foot models, it
will need to be cut to size for 8 foot and 10 foot models.
NOTE
S-tines should not be operated any deeper than
necessary to remove tractor tire tracks. Otherwise, wet
soil is brought up which will stick to the rollers, draft load
is increased, and under some conditions, tines may
deflect back to rollers and break. See Figure 2-13.
Figure 2-13: Tractor Tire Depression
Figure 2-14: S-Tine
Tractor Tire Depression
SUGGESTED SETTING
BDH512 TrackRemoverKitParts
Tube
U-bolt,1/2-13
Lock
Washer Nut
Bolt,
1/2-13 x 6
Strap
Duckfoot
Reversible
Point
S-Tine
Clamp
Long End Down
Bracket
Carriage Bolt
7/16-14 x 3-1/2
Cultivator
Bolt
Lock Nut
3/8-16
Nut,1/2-13
Front Seeder Shown Rear Seeder Similar