Landoll BDH512 Double Seeder Hitch - Manual (Page 23)

ASSEMBLY
2-13
AG Harness Installation
1. Attach Tandem Hauler Adapter to Rear Hitch
Bulkhead just above the Caster Wheel Assembly.
Secure with two 1/4-20 x 1" Hex Capscrew and
Flange Locknut.
2. Plug Ag Harness's flat plug into Tandem Hauler
Adapter.
3. Run Ag Harness forward along the hydraulic hoses
securing cord to hoses where necessary with
provided cable ties.
4. 7-pin Plug end connects to the tractor or is stored in
connector Holder located on the Hose Holder
Bracket that is mounted to the Drawbar. Allow
enough harness length to reach tractor socket. Roll
or fold up excess if necessary with provided cable
ties.
Clutch wiring should follow the same path as the Ag
Harness from the tractor to the Rear Seeder
Figure 2-12: AG Harness Installation
1/4-20 x 1”
Flange Locknut
Tandem Hauler Adapter
Cable Ties
7-Pin Plug