Landoll BDH512 Double Seeder Hitch - Manual (Page 15)

ASSEMBLY
2-5
Caster Wheel Installation
1. Slide the Wear Disk and Bushing onto the Caster
Assembly Pipe.
2. Slide the Caster Assembly Pipe onto the Rear Hitch.
3. The Keeper Plate has two sets of holes. Position it so
that the smallest gap as possible is between the
Keeper Plate and the Rear Hitch Pipe. Line the
appropriate hole up with the Caster assembly Pipe
and secure in place with a 1/2-13 x 6 Hex Capscrew
and Locknut.
4. Remove the Rear Seeder Drawbar Hitch and replace
it with 1P885 Hitch which is longer.
NOTE
Locking collars should be tightened in normal direction of
rotation.
Figure 2-5: Caster Wheel
Keeper Plate
Hitch
Bushing
Wear Disk
Normal Direction
of Rotation
1/2-13 X 6 Bolt
Lock Nut
Caster Assembly