Landoll BDH512 Double Seeder Hitch - Manual (Page 16)

2-6 F-645
ASSEMBLY
Turnbuckle Installation
The turnbuckle is used to adjust the overlap of the
seeders. The hitch is designed so that the left side of the
front seeder will follow exactly on the center line of the
tractor.
1. With the Turnbuckle grease fittings facing forward,
install the square end of the turnbuckle between the
lugs on the Long Hitch. Secure in place with 1 1/4-7 x
5" Hex Capscrew and Locknut.
2. Install bushing end of the Turnbuckle between the
lugs on the Short Hitch. Secure in place with 1- 1/4 x
6-1/2 Hex Capscrew and Locknut.
NOTE
When using seeders of different widths, always attach the
wider seeder to the front hitch, and adjust the location of
the rear seeder by using the turnbuckle.
3. Apply the Brillion decal to the outer tube of the Short
Hitch and the Long Hitch.
Figure 2-6: Turnbuckle Installation
1 1/4-7 x 6-1/2 Capscrew
Locknut
Turnbuckle
1 1/4-7 x 5 Capscrew
Locknut
Brillion Decal 32”
Short Hitch
Long Hitch
Brillion Decal 32”