Landoll BDH512 Double Seeder Hitch - Manual (Page 13)

ASSEMBLY
2-3
Attach the Pivoting Hitches to the
Drawbar
1. Slide a Wear Disk and then a Bushing over each pipe
on the Drawbar,
2. Slide the Short Hitch onto the drawbar front pipe and
the Long Hitch onto the drawbar rear pipe.
3. Each Keeper Plate has 2 sets of holes. Position it so
that the smallest gap as possible is between the
Keeper Plate and the Hitch Pipe. Line the
appropriate hole up with the drawbar pipe and secure
in place with a 1/2-13 x 6 Hex Capscrew and
Locknut.
Figure 2-3: Pivoting Hitches
Wear Disk
Bushing
Long Hitch
Short Hitch
Keeper Plate
1/2-13 x 6 Capscrew
Lock Nut
Drawbar