Landoll BDH512 Double Seeder Hitch - Manual (Page 27)

3-1
Chapter 3
Operations
IMPORTANT
Before operating your Brillion machine check all
hardware for tightness.
After a few hours of initial use, check entire machine
and tighten any loose nuts and bolts. Daily or
periodic checks should be made thereafter

CAUTION
NOTE
Avoid the hazard by relieving pressure before
disconnecting hydraulic lines. On most tractors this can
be done by putting the valve controls in the float position
before the engine is stopped.
Hose Set Up for Both Seeders on One
Hydraulic Circuit
To control both seeders with one hydraulic circuit, remove
the caps on the front seeder bulkhead tee.
1. With the hose still connected, remove the 90 degree
Elbow fitting from the rear seeder straight bulkhead.
2. Connect the 90 degree elbow to the front seeder Tee
bulkhead.
3. Reinstall previously removed caps to the straight
bulkheads.
4. Tie up unused hydraulic hoses.
Figure 3-1: Hose Set Up for Both Seeders on One Hydraulic Circuit
Escaping fluid under pressure can be nearly
invisible and have enough force to penetrate the
skin causing serious injury. Use a piece of
cardboard, rather than hands, to search for
suspected leaks. Wear protective gloves & safety
glasses or goggles when working with hydraulic
systems.