Landoll BDH512 Double Seeder Hitch - Manual (Page 14)

2-4 F-645
ASSEMBLY
Attaching the Rear Portion of the
Long Hitch to the Front Portion
NOTE
The Spring bolts should be installed with the threaded
end pointed to the rear to prevent the threads from
wearing within the slots.
1. Place the sleeve of the Rear Hitch rear portion
between the lugs of the Rear Hitch front portion.
Install pin and roll pins.
2. Install cushion by installing two Spring Bolts, six 3/8”
Thick Washers, two Inner and Outer Compression
Springs and two 3/4-10 Locknuts into the front and
rear portions of the rear Hitch as shown.
3. Tighten the bottom Locknut so that 1-1/2” of thread is
exposed.
4. Tighten the top Locknut so that 1/4” of thread is
exposed.
Figure 2-4: Rear to Front Hitch Installation
1/4"
1 1/2"
Lock Nut
Spring Bolt
Washer
Outer Spring
Inner Spring
Roll Pin
Pin
Long Hitch Front Portion
Long Hitch Rear Portion
Rear Hitch
Factory Assembled