Landoll SS/SSB/SSP/SSBP 8, 10, 12 Sure Stand Seeder - Manual (Page 24)

2-14 1P480
ASSEMBLY INSTRUCTIONS
Scraper Kit (Optional)
(Cannot be used with Coil Tine track Remover Kit) See
Figure 2-16.
1. Assemble the 1K212 brackets onto the front of the
seeder frame tube. The three brackets are provided.
(If you have a wheel track remover kit on your seeder
you will not need these brackets on the outer ends).
You can mount to the same brackets provided with
the wheel track remover. Do not securely fasten at
this time.
2. Attach the vertical brackets loosely and assemble
scraper angle to them. Attach two center scrapers at
center hole locations and then attach all of the
regular scrapers. Center the entire assembly on
implement, then position scrapers for proper fit and
tighten all hardware.
3. Scrapers should be close enough to the wheels to be
functional but not interfere. Some final adjustments
may be required in the field.
Figure 2-14: Scraper Kit (Optional)
Center
Scraper
U-Bolt, 1/2-13
Lockwasher, 1/2 reg
Nut, 1/2-13 Hex Flat Washer , 3/8
Lockwasher, 3/8
Nut, 3/8-16
Carriage
Bolt
Bracket
LH Bracket
Angle
Center
Scraper
Scraper
RH Bracket
HHCS, 1/2-13 x 1 1/4”
Flat Washer, 1/2 std.
Lockwasher, 1/2 reg.
Nut, 1/2-13
1K212