Landoll SS/SSB/SSP/SSBP 8, 10, 12 Sure Stand Seeder User Manual
Page 30
2-20
1P480
ASSEMBLY INSTRUCTIONS
Figure 2-21: Extended Supports
4.
Install the left and right boxes as shown. Left box
fastens to transmission with two 5/16” x 1-1/2” and
two 3/8” x 1” cap screws, lock washers and nuts. Left
box assembly is the one with one hole in the left end
of the 5/8” square shaft. This hole is used only for a
shipping wire.
5.
Install 4C488 washers to hold the bushing. See
Figure 2-23.
6.
Position the shift handles on rear of boxes so the pin
in the bottom of each handle engages the slotted
hole in the slide. Attach handles to shift plates using
1/2” x 1” pivot bolt and flat washer. Tighten bolt just
so the handle can move easily and then lock the bolt
by installing set screw into tapped hole in cast iron
shift plate. See Figure 2-24.
Figure 2-22: Left and Right Agitator Boxes
Extended Supports
A roll pin on each side
of the retainer positions
both shafts.
Retainer
Plate
HHCS 3/8-16 x 1-1/2”
Lock Washer, 3/8
Hex Nut, 3/8-16
HHCS 5/16-18 x 2-1/4”
Lock Washer, 5/16
Hex Nut, 5/16-18
HHCS 5/16-18 x 2-1/4”
Lock Washer, 5/16
Hex Nut, 5/16-18
Right box assembly has two roll pin holes in
the right end of the 5/8” square shaft.
HHCS 3/8-16 x 1-1/2”
Lock Washer, 3/8
Hex Nut, 3/8-16
Left Agitator Box
Right Agitator Box