Landoll SS/SSB/SSP/SSBP 8, 10, 12 Sure Stand Seeder - Manual (Page 28)

2-18 1P480
ASSEMBLY INSTRUCTIONS
Electric Clutch Kit (Optional)
The clutch is controlled by a toggle switch mounted to the
tractor by a hook and loop fastener.
Clutch characteristics are as follows:
1. The clutch is disengaged when power (12 volts) is
applied. If there is a power failure or electrical
problem, the seeder will continue to operate and the
implement must be raised to stop seeding.
2. Seed shafts will not rotate when implement is backed
up.
3. The Switch box contains a standard 5 amp fuse.
4. The clutch must be disengaged (power applied)
when seed shafts are turned manually for calibration.
5. Check that the clutch case has proper clearance
between rubber bumper stop. Improper clearance
may prevent the clutch from engaging or
disengaging. See Figure 2-18.
6. Connect clutch wiring harness to clutch lead, and
route wire along frame and drawbar. Secure to frame
and drawbar or with hydraulic hoses and warning
light harness by cable ties or adhesive mounts.
7. Install switch on tractor in a convenient location with
the Hook and Loop included or other type of mount
(not included).
8. Attach the wire lead to power source and secure
wire.
9. Check clutch operation: Clutch will disengage when
power is applied. (Clutch will make a clicking sound).
Set seeder on the ground and drive a short distance
while turning switch on and off. The seed cup shaft
will stop rotating when switch is turned to “OFF”
position.
10. Turn switch to “ON” position when seeder is not used
to shut off power to prevent possible overheating of
clutch coil.
Figure 2-18: Clutch Clearance
1/8” GAP
Clutch
Bumper Bolt
Clearance from
Bumper Stop