Landoll SS/SSB/SSP/SSBP 8, 10, 12 Sure Stand Seeder - Manual (Page 25)

ASSEMBLY INSTRUCTIONS
2-15
S-Tine Tire Track Remover (Optional)
1. Attach brackets to the frame with u-bolts (1/2” x
4-1/2” centers x 7-1/2” deep), lock washers, and nuts.
Note that the long ends of the brackets are
downward. The brackets should be about 53” from
center of implement. See Figure 2-15.
2. Attach the tube to brackets using straps and bolts
(1/2” x 6”), lock washers, and nuts.
3. Locate and install the S-tines as needed to cover the
tractor tire tracks. The suggested pattern is to use
1-3/8” point on center tine and 2-1/2” points on each
side. If needed, additional tines may be purchased
and installed.
This kit must be used with standard
9J442 long three point hitch on pickup implements.
The Wheel Track Remover is furnished with 6 S-tines.
Additional or fewer tines may be used as required.
NOTE
S-tines should not be operated any deeper than
necessary to remove tractor tire tracks. Otherwise, wet
soil is brought up which will stick to the rollers, draft load
is increased, and under some conditions, tines may
deflect back to rollers and break.
Figure 2-15: S-Tine Setup (Optional)
Tractor Tire Depression
Tooth Tube
Bracket
Assembly
S-Tine
Clamp Carriage
Bolt
2 1/2 Point
1 3/8 Point
SUGGESTED SETTING