Landoll SS/SSB/SSP/SSBP 8, 10, 12 Sure Stand Seeder - Manual (Page 31)

ASSEMBLY INSTRUCTIONS
2-21
Figure 2-23: Box End Bearing
Figure 2-24: Shift Handle
Brush Agitator (Optional)
IMPORTANT
Before proceeding with brush agitator installation, be
sure to determine the direction of shaft rotation on
your particular seeder model. Direction of rotation is
not the same on all models due to transmission
differences. See Figure 2-25.
NOTE
The standard Agitator Box Kit comes with blade agitators.
Optional brush or cage agitators are also available. See
Page 2-22 for information on these options.
Figure 2-25: Shaft Rotation
Agitators are installed in Brillion seeders as follows:
1. Remove two bolts which hold retainer plate and
bearing on right end of right seed box.
2. Slide both shafts out of right end.
3. Observe the diagram of box cross section. See
Figures 2-25 and 2-27. Brush/Blade agitators must
be installed with careful attention to the direction of
shaft rotation. The brushes must face backward,
away from rotation to wipe over the seed openings.

CAUTION
4. Install the rear box reel washers on each end of
agitators to prevent seed leakage out of the bushing
and to reduce agitator end play between bearing
brackets. With the agitators properly seated in the
boxes, replace the drive shafts, end washers and
retainer plate. See Figure 2-26.
Install 4C488 washers
to hold bushing in box
end bearing block.
The brushes will be destroyed if installed
backwards. Apply decal enclosed with kit (5D505)
to front seedbox as a reminder to tractor drive.
ROTATION
REAR
FOR SS8,10,12