Landoll SS/SSB/SSP/SSBP 8, 10, 12 Sure Stand Seeder - Manual (Page 29)

ASSEMBLY INSTRUCTIONS
2-19
Agitator Box (Optional)
Installation of the Agitator (Brome) Box: Loose parts are
shipped in a bag assembly placed in the left seed box.
1. Remove bolts holding rear panel to deflector shield
assembly and reverse rear panels so that upper lips
flare rearward instead of forward. See Figure 2-19.
2. Install coupling on transmission output shaft and
secure with 1/4” x 1-1/2” roll pin. See Figure 2-20.
3. Loosen U-bolts which fasten front seed box to frame
at center and right end. Replace center and right end
support brackets with extended supports which also
have holes for mounting a 2nd box (part 9K853 and
9K854). See Figure 2-21.
Figure 2-19: Deflector Shield
Figure 2-20: Coupling Transmission
Single Box
Configuration
Rear Deflector
reversed to add
Brome Box
Roll Pin
Coupling