Landoll PT Series 10 through 20 Transport Pulverizer - Manual (Page 12)

2-2 9J017
ASSEMBLY
3. If a center bracket is included with the machine, it
must be installed next. Start by clamping the center
brackets between the pair of angle iron clips. Use
Grade 5, 1/2" x 1-3/4" Screws with 1/2" Lockwashers
and Nuts. See Figure 2-2. 4. Place the center bracket at the center of the center
frame. Fasten it using 5/8" x 5-1/2" deep U-bolts or,
on 18' and 20’ machines, a pair of straps and 5/8" x
8" Machine Bolts.
5. Attach the SMV Bracket to the Center Bracket U-bolt
and secure with 5/8-11 Hex Nuts and Washers.
Figure 2-2: Center Bracket Assembly
(This center bracket configuration
is supplied on some models.)
OR
CENTER
BRACKET
SMV BRACKET
SCREW, 1/2” x 1 3/4”
SCREW, 1/2” x 1 1/2”
LOCKWASHER, 1/2”
NUT, 1/2”
NUT, 5/8”
LOCKWASHER, 5/8”
U-BOLT, 5/8”
MACHINE BOLTS, 5/8”
STRAP
SCREW, 1/2” x 2 1/4”
LOCKWASHER, 1/2”
NUT, 1/2”
BEARING ASSEMBLY