Landoll PT Series 10 through 20 Transport Pulverizer - Manual (Page 15)

ASSEMBLY
2-5
Figure 2-5: Wheel and Axle Installation - 2 of 4
6. If the wheel gang has female hardware, slide the
wheel gang end-wise, toward the center bracket,
mating the square bore bearing with the stub shaft on
the center bracket. 7. Install right hand end plate assembly on the center
frame tube: use 5/8-11 x 5 1/2” deep x 6 11/16”
center U-bolt, 5/8” Washers and Nuts on angle
8J099, and 1/2-13 x 7 1/2” deep x 4 1/2” center
U-bolts with 1/2” Lockwashers and Nuts on angle
8J100. See Figure 2-6. While installing, be sure to
mate the bearing with the end plate stub shaft.
Figure 2-6: Wheel and Axle Installation - 3 of 4
U-BOLT, 5/8” MACHINE
BOLTS, 5/8”
STRAP
WHEEL GANG WITH
FEMALE HARDWARE
SCREW, 1/2” x 1 3/4”
SCREW, 1/2” x 1 1/2”
NUT, 5/8”
LOCKWASHER, 5/8”
END
BRACKET
LOCKWASHER, 1/2”
U-BOLT, 5/8”
SCREW, 1/2” x 1 1/2”
NUT, 1/2”
3K321
STRAP
MACHINE
BOLT, 1/2 x 7 1/2”
MACHINE
BOLT, 5/8 x 8”
U-BOLT, 1/2”
3K320
STRAP