Landoll PT Series 10 through 20 Transport Pulverizer - Manual (Page 29)

ASSEMBLY
2-19
P Series10’-16’ Models LED Lamp and
Harness Installation
NOTE
Unless otherwise noted the following installation
instructions apply to all P 10’ - 16’ Models.
1. 10’ Model install outer Light Mount Brackets
approximately 15” from outside frame edge using
1/2-13 U-Bolts, Lockwashers and Nuts. See
Figure 2-20.
2. 12’-16’ Models install the outer Light Mount Brackets
approximately 10-1/2” from outside frame edge using
1/2-13 U-Bolts and 1/2-13 Locknuts. See
Figure 2-20.
3. 10’ Model install the inner Light Mount Brackets
approximately 32” from center line using 1/2-13
U-Bolts and 1/2-13 Locknuts. See Figure 2-20.
4. 12’-16’ Models install the inner Light Mount Brackets
approximately 36” from center line using 1/2-13
U-Bolts and 1/2-13 Locknuts. See Figure 2-20.
5. Install the Amber LED inside the Tube Light Shield,
attach to the inside of the outer Light Mount Bracket
using four 1/4-20 X 1-3/4 Screws. Attach the Decal
Plate and secure with 1/4-20 Locknuts.
6. Attach the Red LED to the inner Light Mount
Brackets using four 1/4-20 X 1-1/2 Screws. Attach
the Decal Plate and secure with 1/4-20 Locknuts.
Ensure the red lens faces rearward.
7. Attach the Light Module to the Light Module Bracket
using two 1/4-20 X 1-1/2 Screws and Locknuts. See
Figure 2-16.
8. Attach the Light Module Bracket to the top side of
frame using 3/8-16 U-Bolts and Locknuts.
IMPORTANT
Cords are marked “Left” and “Right”.
9. Layout the LED Lamp Harness and attach the
harness to the Light Module.
10. Route the left and right 3 plug cords along the left
and right top of frame and connect to each Red LED
Lamp.
11. Route the remaining left and right 2 plug cords along
the left and right top of frame. Plug a 2 plug harness
into each Amber LED Lamp.
12. Layout the 7 Pin Harness and attach the harness to
the Light Module.
13. Route the 7 Pin Harness across the frame and along
the drawbar tube and over to hitch point.
14. Adjust the LED lamp angles so LED’s are vertical.
Adjustment is provided to compensate for high
drawbar heights if used as a companion tool or lower
heights if towed directly behind a tractor. See
Figure 2-15.
15. Tighten all hardware.
16. Bundle and secure any excess cord with tie straps.
17. Apply the reflector decals to Decal Plate Mounts. The
amber reflector decals should be front facing on the
outer Decal Plate Mounts. The red reflector decals
and orange decals should be rear facing on both the
inner and outer Decal Plate Mounts. See
Figure 2-21.
IMPORTANT
All wires must be firmly attached to machine frame
members, or hydraulic lines, so they don’t sag or
become torn loose by field debris. Use the cable and
hose ties provided.
18. Attach the SMV Mount to the frame using 5/8-11
U-Bolts and Locknuts. Attach the SMV sign to the
SMV Mount using 5/16-18 X 1 Screws, Washers and
Locknuts.