Lenze E94AYCEN - Manual (Page 32)

E94AYCEN communication manual (Ethernet)
Commissioning
Configuring the communication module
32
L
EDS94AYCEN EN 9.0 - 09/2012
Codes
6.2.5 Gateway address
The gateway address is required if the Servo Drive 9400 is not located in the same
subnetwork as the PC.
 The gateway address consists of four numbers between 0 and 255, separated by
points, e.g. "127.0.0.0".
 Eight bits are reserved for each of the four numbers, which makes a total of 32 bits.
Codes
6.2.6 MAC-ID
The MAC-ID is a globally unique identifier of an Ethernet-capable device. The MAC-ID is
assigned by the manufacturer and permanently burnt into the device (Lenze
communication module).
 The MAC-ID consists of six hexadecimal numerical codes (00 ... FF) which respectively
are separated from each other by a hyphen, e. g. "00-0A-86-00-00-0A".
 Eight bits are reserved for each one of the six numerical codes, which makes a total
48 bits.
 The MAC-ID consists of the manufacturer's identification mark and a running number
which is clearly assigned by the manufacturer.
Parameter (MXI1): C13001/1 C13001/2 C13001/3 C13001/4
Lenze setting 255 . 255 . 255 . 0
Parameter (MXI2): C14001/1 C14001/2 C14001/3 C14001/4
Lenze setting 255 . 255 . 255 . 0
Parameter (MXI1): C13002/1 C13002/2 C13002/3 C13002/4
Lenze setting 127 . 0 . 0 . 1
Parameter (MXI2): C14002/1 C14002/2 C14002/3 C14002/4
Lenze setting 127 . 0 . 0 . 1