Lenze E94AYCEN - Manual (Page 9)

EDS94AYCEN EN 9.0 - 09/2012
L
9
E94AYCEN communication manual (Ethernet)
About this documentation
Terminology used
1.3 Terminology used
Term Meaning
Drive Lenze controllers of the "Servo Drives 9400" series
Standard device
»Engineer«
Lenze PC software supporting you for the "Engineering" (parameterisation,
diagnostics, and configuration) during the whole life cycle, i. e. from the design
to the maintenance of the machine commissioned.
Code Parameter which serves to parameterise and monitor the drive. In normal usage,
the term is usually referred to as "Index".
Lenze setting This setting is the default factory setting of the device.
Basic setting
HW
Hardware
SW Software
PLC Programmable Logic Controller (PLC)
Use DHCP Dynamic Host Configuration Protocol