Lenze EMF2192IB - Manual (Page 36)

Commissioning
Initial switch−on
6
l
36 EDSMF2192IB EN 3.1
6.4 Initial switch−on
Switch on the drive and check its readiness for operation by means of the diagnostic LEDs
on the front of the communication module.
ƒ Red diagnostic LEDs must not be lit.
ƒ The following signalling should show:
LED Description
Pos. Colour Status
0 green blinking
on
l The EtherCAT connection has been established.
l Data communication of the EtherCAT connection is active.
1 green on
The communication module is supplied with voltage and is connected to the
standard device.
2 green The EtherCAT state machine controls the LED.
blinking
"Pre−operational" or "Safe−operational" state active.
on
The communication module is in the "Operational" status.