Lenze ECSDExxx - Manual (Page 87)

Electrical installation
Power terminals
4
l
87 EDKCSDE040 DE/EN/FR 4.0
Assignment of the plug connectors
Terminal Function Electrical data
X21 Mains connection
X21/L1 Mains phase L1 Dependent on application and
type
0 ... 480 V
up to 31.3 A (
^ 72)
X21/L2 Mains phase L2
X21/L3 Mains phase L3
X21/PE Connection of PE conductor
X22 DC−bus voltage connection
X22/BR0 Internal brake resistor, connection 1 Dependent on application and
type
0 ... 770 V
up to 38.5 A (
^ 72)
X22/BR1 External brake resistor, connection 1
X22/+UG Internal/external brake resistor, connection 2
X22/+UG DC−bus voltage supply, plus
X22/−UG DC−bus voltage supply, minus
X22/PE Connection of PE conductor
Cable cross−sections and screw−tightening torques
Cable type Wire end ferrule Possible cable
cross−sections Tightening torque Stripping length
Terminal strips X21 and X22
Rigid ˘
0.2 ... 10 mm 2
(AWG 24 ... 8)
1.2 ... 1.5 Nm
(10.6 ... 13.3 lb−in)
5 mm for screw
connection
10 mm for spring
connection Flexible
Without wire end
ferrule 0.2 ... 10 mm 2
(AWG 24 ... 8)
With insulated wire
end ferrule 0.25 ... 6 mm 2
(AWG 22 ... 10)
With insulated
TWIN wire end
ferrule
0.25 ... 4 mm 2
(AWG 22 ... 12)
Shielded cables
The following factors decisively determine the effect of the shielded cables:
ƒ Good shield connection
– Ensure a contact surface as large as possible
ƒ Low shield resistance
– Only use shields with tin−plated or nickel−plated copper braids (shields
with steel braids cannot be used).
ƒ High overlap rate of the braid
– At least 70 ... 80 % with 90° overlap angle
The ECSZS000X0B shield mounting kit includes a wire clamp and shield sheet.