Commissioning – Lenze 8210 series User Manual
Page 45
![background image](/manuals/566180/45/background.png)
Commissioning
UONu_^MPMQ
5-9
L
4.Set slip compensation
(C021)
Rough setting by means of the motor data:
4.Set slip compensation
(C021):
л =
е
клуе
− е
к
е
клуе
⋅ NMMB
е
клуе
=
С
Зк
⋅ SM
é
s
Slip constant (C021)
n
rsyn
synchronous motor speed [min
-1
]
n
r
rated speed to motor nameplate [min
-1
]
f
dr
rated frequency to motor nameplate [Hz]
p
Number of pole pairs
Precise setting:
Change C021 under constant load until the speed is near the synchronous speed.
If C021 is set to too high values, the drive may become instable (overcompensation).
Important
D
The change from V/f-characteristic control to motor-current control should only be
carried out when the controller is inhibited.
D
The idle current of the motor (magnetizing current) must not exceed the rated
current of the controller.
D
With very small friction values it is possible that an angle offset of up to 180
°
occurs when enabling the controller.
Show/Hide Bookmarks