Lenze EPM−H606 - Manual (Page 63)

Preface and general information
About these Operating Instructions
1
l
63 EDBPM−H605 DE/EN/FR 7.2
1 Preface and general information
The EPM−H605 and EPM−H606 operating units enable you to access codes of
Lenze controllers, 9300 Servo PLCs and Drive PLCs, and to control them easily.
Communication takes place via the system bus (CAN).
The »HMI Designer« Lenze software allows for easy programming of the
operating units.
1.1 About these Operating Instructions
ƒ These Operating Instructions describe safe and trouble−free working on
and with the EPM−H605 and EPM−H606 operating units.
ƒ All persons working on and with the EPM−H605 and EPM−H606 operating
units must have these Operating Instructions available and observe all
relevant information and notes.
ƒ These Operating Instructions must always be kept as a complete
document and in a readable state.
1.2 Terminology used
Term Used in this text for
Controller Lenze 8200 vector and 9300 vector frequency inverter, Lenze 9300
and 9400 servo inverter
HMI Human Machine Interface
1.3 Scope of supply
Quantity Important
l 1 operating unit
– EPM−H605 with 10 m cable, or
– EPM−H606 with 10 m cable and plug
l 1 Operating Instructions
l 1 wall mounting
l 1 supporting loop
After receipt of the delivery, check immediately
whether the items delivered match the
accompanying papers. Lenze does not accept any
liability for deficiencies claimed subsequently.
Claim
l visible transport damage immediately to the
forwarder.
l visible deficiencies/incompleteness
immediately to your Lenze representative.