Metal Sales Magna-Loc Installation - Manual (Page 37)

© Metal Sales Manufacturing Corporation / Subject to change without notice 6/12
37
MAGNA-LOC
Framing
Tin snips or a "nibbler" type electric tool are recommended for field cutting Magna-Loc panels. Cutting the steel generates
slivers or metal chips. These slivers and metal chips must be immediately removed from the Magna-Loc panels because they
will damage the finish and shorten the life of the product.
One method of preventing this problem is to flip the Magna-Loc panels over when cutting. This allows the slivers and metal
chips to be brushed from the back side and avoids damaging the paint on the top side of the panels.
When cutting Magna-Loc panels, goggles must be worn for eye protection.
CAUTION
All product surfaces should be free of debris at all times. Installed surfaces should be
wiped clean at the end of each work period. Never cut panels over metal surfaces.
Metal shavings will rust on the surface, voiding the warranty.
All painted panels and flashings have a factory applied baked on finish. Handling and installing panels may result in some
small scratches or nicks to the paint finish. Touch-up paint is available in matching colors from Metal Sales. It is recom-
mended that a small brush be used to apply touch-up paint to those areas that are in need of repair. Touch-up paint does not
have the superior chalk and fade resistance of the factory applied paint finish and will normally discolor at an accelerated
rate. Aerosol paint should not be used because of the overspray that may occur.
FIELD CUTTING AND TOUCH-UP
TOUCH-UP PAINT
FIELD CUTTING
TOUCH-UP PAINT
SPRAY PAINT