Metal Sales Magna-Loc Installation - Manual (Page 79)

© Metal Sales Manufacturing Corporation / Subject to change without notice 6/12
79
MAGNA-LOC
z-CLOsure INstALLAtION
INstALLAtION NOtes
Magna-Loc Z-Closure
Field cut and bend back 1"
Double Bead Tape Sealant
Field cut and bend back 1"
1. Place a row of Double Bead Tape Sealant across panel and over each rib approximately 4" from panel end. Before
proceeding, make sure Z-Closure placement will accomodate flashing.
2. Field cut the Z-Closure 2" longer than the panel width. Snip the top and bottom leg of the Z-Closure and bend both sides
back (as shown above).
3. Fasten through the Z-Closure, Tape Sealant, Magna-Loc panel, and substrate with appropriate fasteners.
Note: For Open Framing, the substrate will be the Back-Up Channel shown in the details.
4. Apply a row of Double Bead Tape Sealant across the top of the Z-Closure filling any gaps or openings around the panel
ribs. This will be fastened through when the flashing is installed.
Slope
#12-14 x 1" SD NW
(or) #10-12 x 1" PHW
3:12 slope
Minimum