Metal Sales Magna-Loc Installation - Manual (Page 71)

© Metal Sales Manufacturing Corporation / Subject to change without notice 6/12
71
MAGNA-LOC
VALLey OFFset OVer deCKING
Magna-Loc Panel
Moisture Barrier (by others)
Offset Cleat
Valley
Double Bead Tape Sealant
3" MIN.
Tube Sealant (between panel ribs)
Tube Sealant
#10-12 x 1" PHW
INstALLAtION NOtes
Valley flashing must be installed working from eave to peak if two or more flashings are required. It is recommended
that an ice and water shield be placed along the valley beneath the flashing for added protection against moisture.
1. Install Valley flashing back against substrate. To hold Valley flashing in place fasten to substrate with #10-12 x 1" Pancake
Head fastener, 4'-0"o.c.
2. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of 2" placing a
bead of Tube Sealant between the flashings and securing with Pop Rivets, 2.5"o.c.
3. Place a continuous row of Double Bead Tape Sealant across bottom leg of Offset Cleat and apply to both sides of valley.
4. Fasten through Offset Cleat, Tape Sealant, Valley flashing and into substrate with Pancake Head fastener, 1'-0"o.c.
5. Install Magna-Loc panel by engaging field hemmed panel end (see page 82) over Offset Cleat. Two beads of Tube Sealant
must be applied up and over male leg of each Magna-Loc panel during panel installation (see page 49).
3:12 slope
Minimum