Magna-loc, 20" ridge/hip cover – Metal Sales Magna-Loc Installation User Manual
Page 67
© Metal Sales Manufacturing Corporation / Subject to change without notice 6/12
67
MAGNA-LOC
20" rIdGe/HIp COVer
INstALLAtION NOtes
1. Once panels have been installed, slide Back-Up Channel under upper edge of panels. Position Back-Up Channel to allow
for proper installation of hip assembly. Use C-clamps to hold Back-Up Channel in place.
2. Apply a row of Double Bead Tape Sealant across panel, up and over all ribs approximately 2"-4" from panel end on both
sides of hip.
3. Install field cut Z-Closure over tape sealant. (See page 79 for preparing Z-Closures.) Before continuing make sure Z-
Closure placement will accommodate 20" Hip flashing.
4. Once Closure is set in Tape Sealant, fasten through Z-Closure, Tape Sealant, Magna-Loc panel, and into Back-Up Channel
with (5) #12-14 x 1" SD N/W per panel. C-clamps may be removed once Closures have been fastened.
5. Once all Z-Closures have been installed, place a row of Double Bead Tape Sealant across top of Closures on both sides of
hip. Tube Sealant must be used to fill any and all gaps left around Z-Closures.
6. Install 20" Hip flashing and secure to top leg of Z-Closure with ¼"-14 x
7
/
8
" Stitch XL at the spacing shown above.
7. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of 2" placing a
bead of Tube Sealant between the flashings and securing with Pop Rivets, 2.5"o.c.
Double Bead Tape Sealant
Clip W/ (2)
1
/
4
"-14 x 1
1
/
2
" SD N/W
20" Hip Cover
1
/
4
"-14 x
7
/
8
" Stitch XL (3 per panel)
Magna-Loc Panel (field cut)
Back-up Channel
Z-Closure (field cut)
#12-14 x 1" SD N/W (see below)
#12-14 x 1" SD NW
1
3
2
5
4
FASTENING PATTERN
1
/
2
:12 slope
Minimum