MK Diamond MK-100 Tracker - Manual (Page 11)

MK-100 TRACKER Revision 02/03, Effective Date February 12, 2003 Page 11
UNPACKING, TRANSPORT, UNIVERSAL STAND and ASSEMBLY
UNPACKING:
Your MK-100 TRACKER has been shipped from the factory thoroughly inspected. Only minimal assembly is
required
Use proper lifting techniques when lifting the MK-100 TRACKER.
CONTENTS:
In your container, you will find one (1) MK-100 TRACKER frame and water basin, one (1) MK-100 TRACKER
Cutting, one (1) 10-inch wet cutting continuous rim diamond blade, one (1) adjustable cutting guide, one (1)
electric water pump, one (1) pump discharge fitting, one (1) cooling transfer tube, one (1) flow adjusting
clamp, one (1) drain plug, one (1) blade wrench, one (1) Table Clip, one (1) splash guard, one (1) owners
manual, one (1) pump manual and one (1) warranty card.
MK-100 TRACKER
Frame
and Water Basin
MK-100 TRACKER
Cutting Head
Removable Cutting
Table
Diamond Blade Adjustable
Cutting Guide
Electric
Water Pump
Pump
Discharge Fitting
Cooling
Transfer Tube
Flow
Adjusting Clamp
Drain Plug
Wrench Splash
Guard
Owners
Manual
Pump
Manual
Warranty
Card
TRANSPORT:
1. The MK-100 TRACKER weighs approximately ninety-seven (97) pounds.
2. Never transport the MK-100 TRACKER with water in the Water Basin.
The MK-100 TRACKER is designed with a rigid frame and removable Cutting Head. Two people are required
to transport the MK-100 TRACKER with the Cutting Head installed. The Cutting Head must be removed first,
if one person is transporting the saw (see Cutting Head Installation and Removal in the following section).
Lift Point Lift Point
Cutting Table
Lift the saw using the
lift points shown.
Cutting Head