MK Diamond MK-100 Tracker - Manual (Page 25)

MK-100 TRACKER Revision 02/03, Effective Date February 12, 2003 Page 25
SETUP, ADJUSTMENT and OPERATION
7. Cleanup:
NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of waste water in accordance with applicable Federal, State and Local laws.
Ensure the saw is disconnected before completing the remainder of the cleanup process.
(D)
Ensure the ON/OFF Switch
is in the OFF position
Off
Position
ON/OFF
Switch
(F)
Unplug MK-100 TRACKER
from the GFCI
(E)
Unplug the GFCI from the
Power source
(B)
Place the Water Pump
In an external container
(A)
Clean the Water Pump
suction of all debris
(C)
Run the MK-100 TRACKER
until clear water is seen
at the blade
(H)
Remove the Water Basin
from the MK-100 TRACKER
(I)
Clean the Water Basin
(G)
Clean the MK-100 TRACKER
with soap and clean water
Clean Water
Basin
Soap and
Fresh Water
Pump
Suction
Water Pump
In container
External
Container
Cooling Flow
Points
Unplug
GFCI
Slide Water Basin
out front of Saw