MK Diamond MK-100 Tracker - Manual (Page 24)

MK-100 TRACKER Revision 02/03, Effective Date February 12, 2003 Page 24
SETUP, ADJUSTMENT and OPERATION
6. Adjusting the Post for Maximum Cutting Length:
The Cutting Head and Post are heavy! Care must be used when changing the position of the
Cutting Head.
Hold the Post when removing the Post Support Plate.
(I)
Install the Cutting Head (See
Adjusting the Cutting Head
Cutting
Head
(A)
Ensure the ON/OFF Switch
is in the OFF position
Off
Position
ON/OFF
Switch
(B)
Unplug the GFCI from the
power source
(D)
Remove the Cutting Head (See
Adjusting the Cutting Head
(C)
Remove Water Basin
(E)
Loosen the Post Support Plate
and retaining bolts
(F)
Remove the Post Support Plate
and retaining bolts
(G)
Relocate the Post to the rear
Post retaining holes
(H)
Install and tighten the Post
Support Plate and retaining bolts
(J)
Install the Water Basin
(K)
Plug the GFCI into the
power source
Post Support
Plate
Slide Water Basin
out front of Saw Unplug
Cutting
Head
Turn counter-
clockwise to loosen
9/16-inch
Wrench
Post Rear
Holes
Turn Clockwise
to tighten
9/16-inch
Wrench
Slide Water Basin
in back of Saw
GFCI Plugged
Into Power
Source