MK Diamond MK-100 Tracker - Manual (Page 29)

MK-100 TRACKER Revision 02/03, Effective Date February 12, 2003 Page 29
MAINTENANCE AND TROUBLESHOOTING
4. Flow Adjustment:
NOTE: If flow to the diamond blade requires adjustment, perform the following actions.
(J)
Lubricate the Cutting Head
Adjustment Knob
(I)
Remove the Cutting Head (See
Adjusting the Cutting Head)
(L)
Lubricate the Cutting Head
Pivot Shaft
(K)
Lubricate the Cutting Head
Adjustment Knob retaining holes
(D)
Increase cooling flow by
releasing the Flow Adjusting
Clamp
(E)
Reduce cooling flow by
Pressing down on the Flow
Adjusting Clamp
Cutting
Head
Adjustment
Knob
Retaining
Holes
Pivot
Shaft
Pull Tab
to loosen
Press Tab
to Restrict
Flow