Barco R9806700 - Manual (Page 101)

17. Upgrading Touch Panel D-Cine Premiere
17. UPGRADING TOUCH PANEL D-CINE PREMIERE
17.1 Upgrade Touch Panel
Why upgrade!
After the ACSAR has been mounted in the D-Cine Premiere, proceed to the upload of a new menu structure in order to provided
the Touch Panel with the ACSAR functionality.
Where to find?
For the upgrade of the touch panel, refer to the D-Cine Communicator software manual, edition Post Production or Engineer. See
below the upload procedure.
17.2 Upgrading the Touch panel menu structure
How to upgrade
1. Check the radio button in front of the Touch Panel Menu Structure and click Load. (image 17-1)
A browser window opens.
2. Select the touch panel menu structure file for the Touch Panel. Click on Open.
The new settings will be loaded in the Touch Panel.
Files to upload are typically called depending of the projector configuration. E.g. :
Menu M7 Chinese V2.0 bin Uses Chinese fonts for projector without an ACSAR
Menu M7 Chinese with ACSAR V2.0 bin Uses Chinese fonts for projector with an ACSAR
Menu M7 English V2.0 bin Uses English fonts for projector without an ACSAR
Menu M7 English with ASCAR V2.0 bin Uses English fonts for projector with an ACSAR
Image 17-1
Touch panel upgrade
If the connection to the projector was broken during this upload, you can restart the procedure. It is rec-
ommended to physically power OFF/ON the touch panel before retrying a new Touch panel menus structure
upload.
Typical update timings
Ethernet 14 to 16 minutes
Serial Connection to RS232/422:22 22 to 24 minutes
Serial Connection to Loop In / Out 18 to 20 minutes
R5976519 ACSAR 12122002 97