Barco R9806700 - Manual (Page 35)

8. Operating the Remote Control
8.3 Address setting for the Remote Control
How to set the Remote Control address
1. Point the Remote Control to the module you desire to know the address and press the address key (recessed key).
On-screen and in the graphical display appears the number of the address. Now proceed to program the address in the Remote
Control.
2. Again, press the ADDRESS key on the Remote Control. (image 8-5)
3. Press the digit key, corresponding with the desired address (between 0 and 9), WITHIN 5 SECONDS after the key has been
pressed. (image 8-6)
The commands from the Remote Control are sent with the stored address.
Image 8-5
Address key
Image 8-6
Digit keys
R5976519 ACSAR 12122002 31