Opticon PHL 8000 - Manual (Page 85)

Opticon
PHL 8000 series
User Manual
85
3.2.17. System
Table 3-32. System
Icon Item & Function
General Tab (See Figure 3-95: System: General.)
• To
show:
o Firmware information
o Information about processor type, memory size,
expansion card
Memory Tab (See Figure 3-96: System: Memory.)
• Move the slider to adjust memory allocation. Default storage
memory is normally is normally set to ~54MB with the reminder
assigned to Program memory.
• Press the OK key on the keypad.
NOTE: The difference between the RAM size in Information
Properties and the total memory size of storage memory and
program memory is used by the operating system.
Device Name Tab (See Figure 3-97: System: Device Name.)
• Your device uses this information to identify itself to other
computers.
• The input panel will open to facilitate data entry.
• To close the Device Name, press the OK button, or press the
<Enter> key on keypad.
Copyright Tab (See Figure 3-98: System: Copyright.)
• Refer to this tab for specific copyright data. As a user, you are
responsible for reading this statement.