Opticon PHL 8000 - Manual (Page 92)

Opticon
PHL 8000 series
User Manual
92
5. Software Applications
5.1. Introduction
The PDT includes Calculator, Inbox, etc.
You can switch to any software program by tapping the Start menu.
5.2. Software Applications
5.2.1. Inbox
Use Inbox to send and receive email
messages in the following ways:
• Synchronize email messages with
Microsoft Exchange or Outlook on
the host computer.
• Send and receive email messages by
connecting directly to an email server
through an Internet server provider
(ISP) or a network.
To set up Inbox:
1. Select Start > Programs> Inbox to
open it.
2. Select Service > Options from the
command bar. Drag the dialog to
show the right edge to configure
email.
3. Select Add…
NOTE: To add a mail service, select Add. To remove a mail service, select the
service from the Installed service box and select Remove. To view a mail
service’s properties, select the service from the Installed service box and then
select Properties.
4. In the Service Type list, select POP3 Mail or IMAP4 Mail.
• (POP3 is the most common mail protocol for ISPs). Enter a unique name
for the email service in the “Service name” field. This name cannot be
changed later.
5. Select OK.
6. The Mail Service Setup wizard appears after you add a service.
• If you are adjusting the setting of an existing service, select Service>
Options, select the service you are using, and then Properties. In the
Service Definition dialog box, complete the following entries as needed:
Figure 5-103: Inbox