RKI Instruments M2 Series User Manual
Page 54
Advertising
49
M2 Transmitter Operator’s Manual
WARNING:
The ESM-01 detectors cannot be changed from one type to another.
Replace the plug-in sensor only with the same type of ESM-01 sensor.
5.
Make sure the cap gasket is in place and screw the detector cap back onto the housing
body. If the splash guard was unscrewed from the detector cap, screw it back onto the
detector cap.
6.
Turn on or reconnect power to the M2.
NOTE:
Allow the replacement sensor to warm up for 15 minutes before you continue
with the next step.
7.
Calibrate the detector as described in “Calibration, Combustible Gas, CO2, and Toxic
Versions” on page 40
Advertising