RKI Instruments GD-K71D - Manual (Page 35)

PT2E-1052
34
７−２．Calibration method(Calibration with gas, etc.)
Refer to 「5-5 Maintenance and adjustment」
７−３．Replacement of sensor and parts.
７−４．Treatment when operation is stopped or its installation
place is moved.
７−４−１．Stopping the normal operation
Make the power switch off on the front side.
Make the power (DC24V) off at the supply side.
７−４−２．Installation when move its place
When move its place, refer to “4-2. Installation place”. Then, for wiring
construction, refer to “4-5. Caution at wiring construction”. When move its
installation place, make shortest the power interruption time.
７−５．Storage or treatment when not in use for a long time.
This detector shall be stored in the following environment condition.
①Temperature ：0℃∼40℃
②Humidity ：30%RH∼85%RH(Non-condensing)
③Environment condition：To be an environment where there is no generation of gas,
solvent and vapor etc.
CAUTION
When move its installation place, be sure to make gas calibration. The re-adjustment work
including gas calibration shall be requested to contact our nearest agent or Riken Keiki.
CAUTION
For replacement of sensors and parts etc, contact our nearest agent or Riken Keiki.
CAUTION
For gas calibration, contact our nearest agent or Riken Keiki.
When it is not used for a long time, take care for the life of lithium battery used inside
detector. Replacement interval is 3 years from the date of ex-work(Described in the
sticker on the detector).
When use the detector again, be sure to make calibration.
Please contact with our nearest agent when intending to make re-adjustments
including calibration, replacement of parts, etc.
CAUTION