RKI Instruments GD-K71D - Manual (Page 6)

PT2E-1052
5
２−３．Caution items
○ Do not use a walky-talky around the instrument.
The indication might be affected by the electromagnetic wave generated by the
walky-talky if it is used near the instrument. When the walky-talky is used, be away
enough from the instrument not to affect.
○ Take at least 5 seconds interval when re-turning the power on.
Normal operation cannot be performed if the power is re-turned on within 5 seconds.
○ Confirm the float of the flowmonitor is within two red bars.
If the float gets below the lower red bar, the correct gas detection cannot be
performed. Adjust the flow rate.
○ Equip a dust filter to the outside of the detector if it is used in a dusty place.
The dust filter depends on a measuring gas. Consult our sales agents.
○ Take care not to drop the cover when taking it out.
Dropping the cover might cause a serious injure. Take care.
○ Do not control other equipment by using outputs of this detector.
This is not a control equipment. It is prohibited to control other equipment by using
outputs of this detector.
CAUTION
○ Treatment at gas alarming
It is very dangerous if the instrument detects the gas exceeded the alarm points.
Take any treatment based on your judgment at that time.
WARNING