Rockwell Automation 20-COMM-M Modbus/TCP Adapter - Manual (Page 16)

2-2 Installing the Adapter
20-COMM-M Modbus/TCP Adapter User Manual
Publication 20COMM-UM014C-EN-P
Setting the Web Pages
Switch To use the adapter web pages, the Web Pages Switch must be set to its
“Enable Web” position.
Important: A new switch setting is recognized only when power is applied
to the adapter, or the adapter is reset. If you change a switch
setting, cycle power or reset the adapter to apply the change.
Set the Web Pages Switch SW2 ( Figure 2.1 ) to enable or disable the adapter
web pages. By default, the adapter web pages are disabled. For complete
details on adapter web pages, see
Viewing the Adapter’s Web Pages on
page 6-1 .
Figure 2.1 Setting Web Pages Switch
SW2 Setting Description
Down (OFF) position Disables the adapter web pages (default setting)
Up (ON) position Enables the adapter web pages
2 1 O
N
UNUSED
SWITCH
WEB PAGES
SWITCH
Enable Web
Position
Disable Web
Position