Rockwell Automation 20-COMM-M Modbus/TCP Adapter - Manual (Page 94)

Index-2
20-COMM-M Modbus/TCP Adapter User Manual
Publication 20COMM-UM014C-EN-P
drives, see PowerFlex drives
DriveTools SP software, G-2
duplex communication mode
definition, G-2
selecting, 3-8
E
EDS (Electronic Data Sheet) files
definition/web site, G-3
EEPROM, see Non-Volatile Storage (NVS)
EN Rate Act parameter, B-2
EN Rate Cfg parameter, B-2
environmental specifications, A-2
equipment required, 1-3
Ethernet
cable, 2-6
connector on adapter, 1-1
switch, 2-6
events
clearing/viewing, 5-6
list of, 5-7
F
fault action
configuring the adapter for, 3-9
definition, G-3
fault configuration
configuring the adapter for, 3-10
definition, G-3
faults, see events
features, 1-2
firmware release, P-2
flash update
definition, G-3
guidelines, 3-13
Flt Cfg A1-D2 In parameters, B-4
Flt Cfg Logic parameter, B-4
Flt Cfg Ref parameter, B-4
full duplex, see duplex communication mode
G
gateway, G-3
gateway address
setting with BOOTP, 3-3
setting with parameters, 3-6
Gateway Cfg 1-4 parameters, B-2
grounding the adapter, 2-5
H
half duplex, see duplex communication mode
hardware address
definition, G-3
in diagnostic item, 5-5
on label, 3-3
HIM (Human Interface Module)
accessing parameters with, 3-2
definition, G-3
LCD model, 3-2
LED model, 3-2
hold last
configuring the adapter for, 3-9
definition, G-4
host IDs, G-4
I
I/O
configuring the adapter for, 3-8
definition, G-4
using, 4-3 to 4-8
indirect access method - accessing device
parameters, 4-10
Indirect Par # 1 - 16 parameters, B-5
installation
applying power to the adapter, 2-6
commissioning the adapter, 2-8
connecting to the drive, 2-3
connecting to the network, 2-6
preparing for, 2-1
Internal Interface cables
connecting to the adapter, 2-4
connecting to the drive, 2-4
illustration, 2-4
IP Addr Cfg 1-4 parameters, B-1
IP address
definition/classes, G-4
setting with BOOTP, 3-3
setting with parameters, 3-6
K
Keep-Alive Register, 4-3