Rockwell Automation 20B PowerFlex 700 Drive Components Replacement - Frame 8 - Manual (Page 62)

62 Rockwell Automation Publication 20B-IN024C-EN-P - June 2012
Chapter 3 Component Replacement Procedures
6. Remove the fan.
Install Components
1. Install the new gasket (if the old gasket was damaged).
2. Place the fan assembly into the chassis but not installed in final position.
Leave space for accessing fan cables from the front of the drive.
Take care to not pinch wires.
3. From the front of the drive, connect the fan cables.
4. Place fan assembly in final position in the chassis.
5. On the back of the drive, install the eleven screws for the heatsink fan
cover. Torque to 2.9 N•m (26 lb•in).
TIP
The connectors, one set shown below, are designed so they go
together only one way. The two end sections are flat on one side and
each section has a ridge at the matching edge.
Fan Cover Screw Locations on Back of Drive
Four on top and bottom
for a total of eight
Three on right side
NOTE: No screws on left side
Fan Assembly
(Front View),
Removed from Drive
Ridges
Flat Sections
Connectors shown
slightly separated