Rockwell Automation 20B PowerFlex 700 Drive Components Replacement - Frame 8 - Manual (Page 71)

Rockwell Automation Publication 20B-IN024C-EN-P - June 2012 71
Component Replacement Procedures Chapter 3
MOV Surge Suppressor -
AC Input Only See Chapter 1 - Component Diagrams and Torque Specifications to locate the
component detailed in these instructions.
Remove Components
1. Read and follow the
Safety Precautions on page 12 and Important Initial
Steps on page 13 .
2. Remove the stacking panel as detailed on page 26 .
3. Note wire placement and connections. Disconnect the MOV ground wire
and the R, S, and T wires to the AC busbars.
4. Remove the MOV mounting nut.
5. Remove the MOV assembly.
Install Components
1. Install the new MOV assembly. Torque the MOV mounting nut to
2.9 N•m (26 lb•in).
2. Connect all wires and connectors for the MOV.
3. Torque the R, S, and T Phase power terminal block screws to 2.9 N•m
(26 lb•in).
4. Torque the ground wire nut to 9.0 N•m (80 lb•in).
5. Install the stacking panel as detailed on
page 27 .
6. Replace all safety shields and enclosure covers before applying power to the
drive.
MOV