Rockwell Automation 442L SC300 Safety Sensor User Manual - Manual (Page 26)

24 Rockwell Automation Publication 10000202762 Ver 00 - January 2012
Chapter 4 Mounting
Mounting in a frame
Figure 15 - Mounting in a frame
Notes
Always mount the camera with at least two screws and use the fastening openings on two
opposite sides of the housing.
Secure the two fixing screws against unintentional loosening.
Always use washers under the screws (Figure 15).
Use sliding nuts suitable for the profile system employed for mounting the camera.
Pay attention to the thickness of the flange on the camera when selecting a suitable screw
length (see “Dimensional drawings” section on page 50).
Mounting the reflective tape
Prior to mounting the reflective tape, pay attention to the following notes:
Notes
Plan the attachment of the reflective tape exactly prior to bonding it in place. The
adhesive on the reflective tape is very resilient. It is not possible to remove the tape again
without destroying it. You will need a suitable solvent to remove the reflective tape (see
“Accessories” section on page 53).
If you must bond the reflective tape in several sections, then ensure there are no gaps,
folds or offset at the joints. The reflective tape must run seamlessly along the contour to
be monitored.
Only the longest contiguous section of the reflective tape is taught-in by the SC300. If
there are gaps in the reflection, the safety camera system will ignore the shorter section of
the reflective tape.
SC300
R
Protect unmonitored areas using mechanical guards!
Take organizational measures to protect the un-monitored
areas (see page 20).
ATTENTION